Mohamed ArshadProfessional,high quality,good service
JohnA great variety of goods， good package，good production line，High-end product，Pay attention to details
BillotReliable , good supervision of production
Cast Iron Scotch Yoke Pneumatic Actuator , Single Acting Pneumatic Actuator
100 psi Scotch Yoke Pneumatic Actuator,
Cast Iron Scotch Yoke Pneumatic Actuator,
689kPa single acting pneumatic actuator
Reliable, Long Lasting Performance Pneumatic Cylinder Operator Single Acting Scotch Yoke Pneumatic Actuator
FLUITECH CONTROL designs and manufactures motorized valves, pneumatic valves and Hydraulic operated valves in three valve series.
This is a Single Acting Cylinder intended for pneumatic service.
Maximum cylinder supply pressure is 100 psi (689 kPa). For maximum cylinder life, the air should be filtered and dry.
If the cylinder is disassembled, lubricate the cylinder wall, piston seal, O-ring and O-ring groove using one of these lubricants.
The set screw in the end of the cylinder is used to limit the stroke of the cylinder. Adjust the set screw so the piston rod contacts it when the valve is in the closed position. Lock the set screw in place with the nut. Be sure the thread seal is positioned properly.
|Relieve the pressure in the pipeline and close the valve.|
|2||Shut off the air supply to the cylinder.|
|3||Relieve the pressure in the cylinder.|
|4||Disconnect the cylinder tubing.|
|5||Remove the nuts and washers from the tie rods and remove the cylinder cap.|
|6||Remove the O-ring from the cylinder cap.|
|7||Remove the cylinder tube, rotating it while pulling it off the piston.|
|8||Remove the nut on the piston rod and remove the piston.|
|9||Remove the piston seal and its O-ring. Clean the O-ring, seal and groove.|
|10||Remove the extension cap from the other end of the housing.|
• Servicing the actuator while the pipeline is under pressure can cause personal injury or equipment damage. Relieve pipeline pressure before servicing the actuator.
• Accidental operation of power actuator can cause personal injury or equipment damage. Disconnect and lock out power to actuator before servicing.
|1||Eccentric Valves: Remove the nuts and spring washers from the rack rod. All other valves: Remove the jam nuts from the rack rod.|
|2||Pull the piston rod (complete with rack rod) from the cylinder head.|
|3||Take out the four screws and separate the cylinder head from the actuator housing.|
|4||Remove the rod seal and O-ring from the cylinder head.|
This is a PRESSURE CONTAINING VESSEL. Release the pressure from both ends of the cylinder before attempting any disassembly or repair.